Benefits

Rowing for CrossFit & Hybrid Athletes

Jordan Lockwood (BSc, CPT)Updated September 2025

The erg is in every box for a reason, and most people who use it three times a week have never been taught to row. That is a large, cheap margin: a strong athlete with a poor stroke is routinely twenty seconds slower over 2,000m than the same athlete with a decent one, and the fix is technical rather than physical.

This is about getting faster on the machine in the context you actually use it: mixed with barbell work, under fatigue, measured in splits that determine where you finish.

Why strong athletes row badly

Three faults account for most of it, and all three come from treating the erg like a lift.

Damper at 10. It feels like effort and it is the most common mistake in the room. A high damper is a gearing choice, not a difficulty setting — it makes each stroke heavier and slower, which rewards strength and punishes everything else, especially under fatigue when your rate drops anyway. Most competitive rowers train at 3–5. Set yours there and your 2k will improve inside a week. Our drag factor guide explains what the number actually controls.

Pulling with the arms and back. The leg drive produces the majority of the power in a well-executed stroke. Athletes who deadlift well instinctively lead with the back, which both leaks power and loads the lumbar spine exactly when you need it fresh for the next movement.

Rating too high. Sprinting at 36 strokes a minute with a short, weak stroke moves less water than 28 with a long, powerful one — rate and pace are not the same thing.[1] Watch the split, not the rate. Our stroke rate guide covers the relationship between rate, power and pace.

The stroke, in one paragraph

Legs, then body, then arms on the drive. Arms, then body, then legs on the recovery. Push the floor away with the legs while the arms stay straight and the back stays braced; once the legs are nearly down, swing the body back; only then draw the handle to the bottom of the ribs. Reverse it exactly on the way back, and let the recovery take about twice as long as the drive. That sequence is the whole sport, and our form guide breaks each phase down properly.

Where you should be

Rough targets for a trained CrossFit athlete. "Solid" is where a competent, reasonably fit athlete lands; "strong" is where you stop losing time to the erg in a workout.

PieceSolidStrong
500mThe one everyone has done. Pure power — and the one that flatters big lifters.1:35–1:45under 1:30
1,000mAppears in Jackie and a hundred other workouts. Long enough to punish a bad opening 250m.3:30–3:50under 3:20
2,000mThe benchmark. Where a strength athlete's engine is genuinely exposed.7:00–7:30under 6:45
5,000mRare in a metcon, common in testing. Tells you whether you have an aerobic base or just grit.19:00–20:30under 18:30

These are open-age, broadly male-skewed figures of the kind usually quoted in gyms, and they ignore bodyweight entirely — which matters, because a heavier athlete produces more power and the same raw time is a bigger achievement from a lighter one. For a version adjusted for your age and gender, and a weight-adjusted score, use the performance standards tool and the 2k calculator.

Pacing an erg inside a workout

The erg is where metcons are won and lost, almost always by going out too hard. A 500m row at the start of a triplet that costs you ninety seconds of recovery on the barbell was not a fast 500m — it was an expensive one.

The practical rule: row the erg portion two to four seconds a split slower than your flat-out pace for that distance, and arrive at the next movement able to start it immediately. For repeated intervals, pick a split you can hold on the last round and row every round at it — negative splitting a metcon beats fading, every time.

Work out your own numbers rather than guessing: the pace zones calculator converts your 2k into target splits for each effort level, and the time predictor tells you what your 500m implies about your 2k and vice versa.

Adding rowing that doesn't wreck your lifting

The mistake hybrid athletes make is adding more hard rowing, because hard is what the box trains. You already have plenty of high-intensity work; what is usually missing is the easy aerobic base underneath it, and that is the thing that improves your 2k and your recovery between rounds.

Two additions are enough. One easy 30–40 minute row a week, genuinely conversational, on a rest or light day — this is aerobic base work and it will not interfere with lifting if you keep it easy. And one technical interval session, something like 6 × 500m at 2k pace with full recovery, where the point is holding a good stroke rather than surviving. Our interval workouts and steady-state guide have sessions for both.

If you want a structured block rather than two bolt-on sessions, the sub-7:00 2k plan is eight weeks aimed squarely at the gap most strength athletes have, and the plan builder will size one around however many days you can spare.

If you're buying an erg for a home gym

Buy the one the sport is measured against. The standard is near-universal in CrossFit for a reason — the data is comparable, the machine is effectively indestructible, and the resale value is extraordinary. See our best rowing machines for CrossFit and the Concept2 Model D review. If the budget doesn't reach, a used one at ten years old will outlast most new alternatives.

References

  1. Rowing Stroke Rate Explained - Concept2
  2. What Damper Setting and Drag Factor to Use on the Concept2 RowErg - Concept2
  3. Understanding Splits - Concept2

Frequently asked questions

What damper setting should CrossFit athletes use on the rower?
Three to five, not ten. A high damper is heavier gearing, not a harder workout - it rewards raw strength and punishes everything else, especially late in a metcon when your rate has already dropped.
What is a good 2k row time for CrossFit?
Around 7:00-7:30 is solid for a trained athlete, and under 6:45 means the erg has stopped costing you time in workouts. Those are open-age figures that ignore bodyweight, so a lighter athlete's equivalent time is faster than it looks.
How should you pace a row inside a workout?
Two to four seconds a split slower than your flat-out pace for that distance, so you can start the next movement immediately. A fast row that costs ninety seconds on the barbell afterwards was an expensive one.
Jordan Lockwood

Jordan Lockwood (BSc, CPT)

Certified personal trainer (CPT), sports-science graduate, and lifelong rower. Jordan writes and reviews every guide on Rowing Machine Nerd.